Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

DTC    C146E    Open in ABS Solenoid Relay Circuit

DTC    C146F    Short in ABS Solenoid Relay Circuit

for Preparation Click here


DESCRIPTION

The ABS solenoid relay is built into the master cylinder solenoid.
This relay supplies power to each ABS solenoid. After the ignition switch is turned ON, if the initial check is OK, the relay turns on.

DTC No.
DTC Detecting Conditions
Trouble Areas
C146E
When either of following condition detected:
  1. Both of following conditions continue for at least 0.2 seconds.
    1. IG voltage between 9.5 V and 17 V.
    2. Relay contact open when relay ON
  2. Both of the following conditions continue for at least 0.2 seconds.
    1. IG voltage 9.5 V or less when relay ON.
    2. Relay contact remains open.
  1. ABS NO. 2 fuse
  2. ABS solenoid relay
  3. ABS solenoid relay circuit
  4. Master cylinder solenoid
C146F
The following condition continues for at least 0.2 seconds.
  1. Relay contact closed immediately after turning IG switch to the ON position when the relay OFF.
  1. ABS NO. 2 fuse
  2. ABS solenoid relay
  3. ABS solenoid relay circuit
  4. Master cylinder solenoid

WIRING DIAGRAM


C124765E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ABS NO. 2)


    F051653E10
  1. Remove the ABS NO. 2 fuse from the engine room R/B and J/B.

  1. Measure the resistance of the ABS NO. 2 fuse.

    Standard Resistance:
    Below 1 Ω

  1. Reinstall the ABS NO. 2 fuse.



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


2.INSPECT SKID CONTROL ECU CONNECTOR (+BS TERMINAL VOLTAGE)


    F051654E09
  1. Disconnect the skid control ECU connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    S1-31 (+BS) - Body ground
    10 to 14 V

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS OR CONNECTOR (GND - BODY GROUND)


    C124799E01
  1. Disconnect the skid control ECU connectors.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    S1-1, 32 (GND1, GND2) - Body ground
    Below 1 Ω
    S2-4 (GND3) - Body ground
    Below 1 Ω

  1. Reconnect the skid control ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK


4.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are recorded.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)