Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster) > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped are detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from OFF to the ON position.

WIRING DIAGRAM


F051289E06


INSPECTION PROCEDURE

1.INSPECT DLC3 (TS TERMINAL VOLTAGE)


    F100115E37
  1. Turn the ignition switch to the ON position.

  1. Measure the voltage.

    Standard:
    Tester Connection
    Specified Condition
    D4-12 (TS) - D4-4 (CG)
    10 to 14 V

  1. Turn the ignition switch to OFF.



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)


    C124792E03
  1. Disconnect the skid control ECU (master cylinder solenoid) connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-24 (TS) - D4-12 (TS)
    Below 1 Ω

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-24 (TS) - Body ground
    10 kΩ or higher

  1. Reconnect the skid control ECU (master cylinder solenoid) connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)  

3.CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3)


    F100115E35
  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    D4-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)


    C124792E03
  1. Disconnect the skid control ECU (master cylinder solenoid) connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-24 (TS) - D4-12 (TS)
    Below 1 Ω

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-24 (TS) - Body ground
    10 kΩ or higher

  1. Reconnect the skid control ECU (master cylinder solenoid) connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)