AUTOMATIC TRANSMISSION SYSTEM > DTC CHECK / CLEAR |
| Pending DTC | Store condition | Malfunction detected |
| Clear condition | System determined to be normal. or DTCs cleared using Techstream. or Cable disconnected from negative battery terminal. | |
| Current DTC | Store condition | Malfunction detected (2nd trip). |
| Clear condition | No malfunctions in 40 driving cycles. or DTCs cleared using Techstream. or Cable disconnected from negative battery terminal. | |
| Permanent DTC | Store condition | Malfunction detected (2nd trip). |
| Clear condition | Ignition switch turned to ON after no malfunction is detected in 3 consecutive driving cycles. or After DTCs cleared using Techstream or cable disconnected from negative battery terminal, malfunction not detected when universal trip performed. | |
| MIL | ON | Malfunction detected (2nd trip). |
| OFF | Ignition switch turned to ON after no malfunction is detected in 3 consecutive driving cycles. or DTCs cleared using Techstream. or Cable disconnected from negative battery terminal. |


| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Pending and Current DTC) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Clear the DTCs.
| CLEAR DTC (Pending and Current DTC without using Techstream) |
Perform either of the following operations:
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI MAIN and ETCS fuses from the engine room relay block located inside the engine compartment for more than 1 minute.
| CLEAR PERMANENT DTC |

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check if permanent DTCs are stored.
Clear DTCs.
Perform the universal trip.
Turn the ignition switch off.
Wait 15 seconds.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check that the permanent DTCs have been cleared.