AUTOMATIC TRANSMISSION SYSTEM > CHECK MODE PROCEDURE |
| DESCRIPTION |
| CHECK MODE PROCEDURE |
Ensure the following conditions:
Battery positive voltage 11 V or more
Throttle valve fully closed
Shift lever in P or N
A/C switched off
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
![]() |
Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.
Start the engine. The MIL should turn OFF after the engine starts.
Perform "Monitor Drive Pattern" for the ECT test (Click here).
(Or, simulate the conditions of the malfunction described by the customer).
After simulating the malfunction conditions, use the Techstream diagnosis selector to check the DTC and freeze frame data.