AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF.
Lift the vehicle up.
Remove the test plug on the transmission case center right side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.
Measure the line pressure while the engine is idling.
Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.
Perform the line pressure test again with the shift lever in R.
| Condition | D Position | R Position |
| Stall test | 1200 to 1450 kPa (12.2 to 14.8 kgf/cm2, 174 to 210 psi) | 1100 to 1350 kPa (11.2 to 13.8 kgf/cm2, 159 to 196 psi) |
| Problem | Possible Cause |
| Measured values are higher than specified in all positions |
|
| Measured values are lower than specified in all positions |
|
| Pressure is low in D position only |
|
| Pressure is low in R position only |
|