Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

DTC    C1225    SM Solenoid Circuit

DTC    C1226    SA2 Solenoid Circuit

DTC    C1468    SFR Solenoid Circuit

DTC    C1469    SFL Solenoid Circuit

DTC    C146A    SRR Solenoid Circuit

DTC    C146B    SRL Solenoid Circuit

for Preparation Click here


DESCRIPTION

The solenoid goes on when signals are received from the skid control ECU (master cylinder solenoid) and controls the pressure action on the wheel cylinders thus controlling the braking force.

DTC No.
DTC Detecting Conditions
Trouble Areas
C1225
Open or short in SMCR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SMCR circuit
C1226
Open or short in SREA circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SREA circuit
C1468
Open or short in SFRH or SFRR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SFRH or SFRR circuit
C1469
Open or short in SFLH or SFLR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SFLH or SFLR circuit
C146A
Open or short in SRRH or SRRR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SRRH or SRRR circuit
C146B
Open or short in SRLH or SRLR circuit continues for 0.05 seconds or more.
  1. Master cylinder solenoid
  2. SRLH or SRLR circuit

WIRING DIAGRAM


C124765E02


INSPECTION PROCEDURE

1.RECONFIRM DTC

HINT:
This DTCs are set when a problem is identified in the master cylinder solenoid.
The solenoid circuit is in the master cylinder solenoid.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTCs are output before replacing the master cylinder solenoid.

  1. Clear the DTC (Click here).

  1. Check if the same DTCs are detected.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)