Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

DTC    C1242    Open Circuit in IG1/IG2 Power Source Circuit

for Preparation Click here


DESCRIPTION

If there is a problem with the skid control ECU (master cylinder solenoid) power supply circuit, the skid control ECU outputs the DTC and prohibits operation under the fail safe function.
If the voltage supplied to terminal IG1 and/or IG2 is not within the DTC detection threshold due to malfunctions in parts such as the battery or alternator circuit, this DTC is stored.

DTC No.
DTC Detecting Condition
Trouble Areas
C1242
Vehicle speed 3 km/h (1.9 mph) or more and voltage of skid control ECU (master cylinder solenoid) terminal IG1 and/or IG2 remains at below 6.5 V for more than 7 seconds.
  1. Battery
  2. IC regulator
  3. Power source circuit
  4. Skid control ECU (master cylinder solenoid)

WIRING DIAGRAM


C173575E03


INSPECTION PROCEDURE

1.INSPECT BATTERY
  1. Check the battery voltage.

    Standard Voltage:
    10 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


2.INSPECT FUSE (IGN FUSE)


    G035653E02
  1. Remove the IGN fuse from the driver side J/B.

  1. Measure the resistance of the IGN fuse.

    Standard Voltage:
    Below 1 Ω

  1. Reinstall the IGN fuse.



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


3.INSPECT SKID CONTROL ECU TERMINAL VOLTAGE (IG2 TERMINAL)


    C247413E01
  1. Disconnect the skid control ECU (master cylinder solenoid) connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    S2-1 (IG2) - Body ground
    10 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid))
  1. Reconnect the skid control ECU (master cylinder solenoid) connector.

  1. Turn the ignition switch to OFF.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL)


    C124799E01
  1. Disconnect the skid control ECU (master cylinder solenoid) connectors.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    S1-1 (GND1) - Body ground
    Below 1 Ω
    S1-32 (GND2) - Body ground
    Below 1 Ω
    S2-4 (GND3) - Body ground
    Below 1 Ω

  1. Reconnect the skid control ECU (master cylinder solenoid) connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Drive the vehicle at a speed of 3 km/h (1.9 mph) or more for 7 seconds or more.

  1. Check if the same DTCs are detected.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)