Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)

DTC    C1254    Pressure Sensor or Switch

for Preparation Click here


DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.

C124776E01


DTC No.
DTC Detecting Condition
Trouble Areas
C1254
Accumulator pressure sensor fault
(Fluid pressure does not change when it should e.g. pump operates, brake pedal depressed/released).
  1. Hydraulic brake booster
  2. Accumulator pressure sensor
  3. Master cylinder pressure sensor

INSPECTION PROCEDURE

1.READ VALUE USING DATA LIST (ACCUMULATOR SENSOR)
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to OFF.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to the ON position.

  1. Select the Data List mode on the Techstream.

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor
    Accumulator pressure sensor reading / min.: 0 V, max.: 5 V
    3.58 to 5 V
    -

  1. Confirm whether the accumulator output voltage is normal.

    Result
    Proceed to
    Output value normal
    A
    Output value not normal
    B



B
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


2.READ VALUE USING DATA LIST (MASTER CYLINDER PRESSURE SENSOR)
  1. Turn the ignition switch to OFF.

  1. Depress the brake pedal more than 20 times.

  1. Install a brake pedal effort gauge (SST), and bleed air.

  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Select the Data List mode on the Techstream.

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Master Cylinder Sensor
    Master cylinder pressure sensor reading / min.: 0 V, max.: 5 V
    0.3 to 1.9 V
    With pedal pressure of 49 N (5 kgf, 11 lbf)
    Front brake pressure: 770 to 1280 kPa (7.9 to 13.1 kgf/cm2, 112 to 186 psi)

  1. Check that the master cylinder output value is in the Normal Condition range.

    OK:
    Master cylinder pressure sensor value is in the Normal Condition.



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK


3.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to OFF.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to the ON position.

  1. Wait until the pump motor stops.

  1. Depress the brake pedal and release it.

  1. Wait for 25 minutes.

  1. Check if the same DTCs are recorded.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)