Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR (for Regular Cab)

SIDE AIRBAG SENSOR (for Regular Cab) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
  1. Confirm that the ignition switch is turned off.

  1. Confirm that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B203555E01
  1. Engage the guide and install the airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Do not use a side airbag sensor that has been dropped.
    2. Do not subject the side airbag sensor to any impact or force.

  1. Confirm that there is no looseness by shaking the side airbag sensor.

  1. Connect the airbag connector.



2. INSTALL FRONT DOOR SCUFF PLATE
  1. Engage the 8 claws and clip, and install the front door scuff plate.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSPECT SRS WARNING LIGHT
  1. Inspect SRS warning light (Click here).