SIDE AIRBAG SENSOR (for Access Cab) > INSTALLATION |
| 1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY |
Confirm that the ignition switch is turned off.
Confirm that the cable is disconnected from the battery negative (-) terminal.
![]() |
Engage the guide and install the airbag sensor with the bolt.
Confirm that there is no looseness by shaking the side airbag sensor.
Connect the airbag connector.
| 2. INSTALL REAR DOOR SCUFF PLATE |
Engage the 7 claws and install the rear door scuff plate.
| 3. INSTALL FRONT DOOR SCUFF PLATE |
Engage the 9 claws and clip, and install the front door scuff plate.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT SRS WARNING LIGHT |
Inspect SRS warning light (Click here).