TOWING CONVERTER RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT TOWING CONVERTER RELAY |
![]() |
Check the power source circuit and ground circuit.
| *a | Front view of wire harness connector (to Towing Converter Relay) |
Disconnect the connector from the towing converter relay.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T20-3 - Body ground | Ignition switch ON | 11 to 14 V |
| T20-3 - Body ground | Ignition switch OFF | 0 V |
| T20-1 - Body ground | Always | 11 to 14 V |
| T20-11 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T20-4 - Body ground | Always | Below 1 Ω |
Check the output operation signal.
Connect the connector to the towing converter relay.
![]() |
Measure the voltage according to the value(s) in the table below.
| *a | Component with harness connected (Towing Converter Relay) |
| Tester Connection | Switch Condition | Specified Condition |
| T20-8 - Body ground | Hazard switch OFF → ON | 0 V → 11 to 14 V (60 to 120 times per minute) |
| T20-17 - Body ground | ||
| T20-18 - Body ground | ||
| T20-8 - Body ground | Turn signal switch (right turn) OFF → ON | 0 V → 11 to 14 V (60 to 120 times per minute) |
| T20-17 - Body ground | ||
| T20-18 - Body ground | ||
| T20-8 - Body ground | Turn signal switch (right turn) ON → OFF | 11 to 14 V (60 to 120 times per minute) → 11 to 14 V |
| T20-17 - Body ground | ||
| T20-18 - Body ground | ||
| T20-2 - Body ground | Hazard switch OFF → ON | 0 V → 11 to 14 V (60 to 120 times per minute) |
| T20-9 - Body ground | ||
| T20-10 - Body ground | ||
| T20-2 - Body ground | Turn signal switch (left turn) OFF → ON | 0 V → 11 to 14 V (60 to 120 times per minute) |
| T20-9 - Body ground | ||
| T20-10 - Body ground | ||
| T20-2 - Body ground | Turn signal switch (left turn) ON → OFF | 11 to 14 V (60 to 120 times per minute) → 11 to 14 V |
| T20-9 - Body ground | ||
| T20-10 - Body ground | ||
| T20-6 - Body ground | Turn signal switch (left turn) OFF → ON | 11 to 14 V → 0 V |
| T20-7 - Body ground | Turn signal switch (right turn) OFF → ON | 11 to 14 V → 0 V |
| T20-12 - Body ground | Hazard switch OFF → ON | 11 to 14 V → 0 V |
| T20-16 - Body ground | Depress brake pedal | 11 to 14 V |