Home › BRAKE › BRAKE CONTROL › DOWNHILL ASSIST CONTROL SWITCH

DOWNHILL ASSIST CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT DOWNHILL ASSIST CONTROL SWITCH


    C189369E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 4
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    If the value is not as specified, replace the downhill assist control switch.