Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data from an external device to the multi-media interface ECU through this circuit.

WIRING DIAGRAM


E232735E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the M5 multi-media interface ECU connector.

  1. Disconnect the N3 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M5-2 - N3-2
    Always
    Below 1 Ω
    M5-3 - N3-3
    Always
    Below 1 Ω
    M5-2 - Body ground
    Always
    10 kΩ or higher
    M5-3 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)