Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

The extension module receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna, and then adjusts vehicle position.

WIRING DIAGRAM


E226280E08


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)
  1. Disconnect the R19 radio and display receiver assembly connector.

  1. Disconnect the E15 extension module connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R19-2 (SPD) - E15-18 (SPD)
    Always
    Below 1 Ω
    R19-2 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)