NAVIGATION SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the R16 radio and display receiver assembly connector.
Disconnect the S23 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S23-3 (L+) - R16-9 (L+) | Always | Below 1 Ω |
| S23-2 (L-) - R16-19 (L-) | Always | Below 1 Ω |
| S23-5 (R+) - R16-8 (R+) | Always | Below 1 Ω |
| S23-4 (R-) - R16-18 (R-) | Always | Below 1 Ω |
| S23-6 (SGND) - R16-10 (SLD) | Always | Below 1 Ω |
| S23-3 (L+) - Body ground | Always | 10 kΩ or higher |
| S23-2 (L-) - Body ground | Always | 10 kΩ or higher |
| S23-5 (R+) - Body ground | Always | 10 kΩ or higher |
| S23-4 (R-) - Body ground | Always | 10 kΩ or higher |
| S23-6 (SGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||