Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio and display receiver assembly, extension module or speakers.

WIRING DIAGRAM


E232750E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the R15 radio and display receiver assembly connector.

  1. Disconnect the N3 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R15-25 (ADPG) - N3-8
    Always
    Below 1 Ω
    R15-26 (VAR+) - N3-5
    Always
    Below 1 Ω
    R15-28 (VAL+) - N3-6
    Always
    Below 1 Ω
    R15-27 (VA-) - N3-7
    Always
    Below 1 Ω
    R15-11 (AGND) - N3-9
    Always
    Below 1 Ω
    R15-25 (ADPG) - Body ground
    Always
    10 kΩ or higher
    R15-26 (VAR+) - Body ground
    Always
    10 kΩ or higher
    R15-28 (VAL+) - Body ground
    Always
    10 kΩ or higher
    R15-27 (VA-) - Body ground
    Always
    10 kΩ or higher
    R15-11 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)