NAVIGATION SYSTEM > Navigation Voice Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the R16 radio and display receiver assembly connector.
Disconnect the S23 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R16-16 (IVO+) - S23-23 (INT+) | Always | Below 1 Ω |
| R16-17 (IVO-) - S23-22 (INT-) | Always | Below 1 Ω |
| R16-16 (IVO+) - Body ground | Always | 10 kΩ or higher |
| R16-17 (IVO-) - Body ground | Always | 10 kΩ or higher |
| R16-14 (SLD1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||