Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Woofer Speaker Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the No. 1 speaker assembly with box.

WIRING DIAGRAM


E232756E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (NO. 1 SPEAKER ASSEMBLY WITH BOX - BATTERY AND BODY GROUND)


    E232760E01
  1. Disconnect the S30 No. 1 speaker assembly with box connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    S30-7 (+B) - Body ground
    Always
    11 to 14 V
    S30-3 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S30-8 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Speaker Assembly with Box)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)