Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

The extension module sends the sound signal to the radio and display receiver assembly through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio and display receiver assembly, extension module or speakers.

WIRING DIAGRAM


E233352E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)
  1. Disconnect the R20 radio and display receiver assembly connector.

  1. Disconnect the E15 extension module connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R20-4 (L+) - E15-15 (L+)
    Always
    Below 1 Ω
    R20-5 (L-) - E15-14 (L-)
    Always
    Below 1 Ω
    R20-2 (R+) - E15-13 (R+)
    Always
    Below 1 Ω
    R20-3 (R-) - E15-12 (R-)
    Always
    Below 1 Ω
    R20-1 (SHD3) - E15-28 (SHD3)
    Always
    Below 1 Ω
    R20-4 (L+) - Body ground
    Always
    10 kΩ or higher
    R20-5 (L-) - Body ground
    Always
    10 kΩ or higher
    R20-2 (R+) - Body ground
    Always
    10 kΩ or higher
    R20-3 (R-) - Body ground
    Always
    10 kΩ or higher
    R20-1 (SHD3) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)