Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU

for Preparation Click here


DESCRIPTION

The multi-media interface ECU sends the sound signal to the radio receiver assembly through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM


E232749E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the R14 radio receiver assembly connector.

  1. Disconnect the M4 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R14-2 (CDR+) - M4-2 (URO+)
    Always
    Below 1 Ω
    R14-3 (CDR-) - M4-3 (URO-)
    Always
    Below 1 Ω
    R14-4 (CDL+) - M4-4 (ULO+)
    Always
    Below 1 Ω
    R14-5 (CDL-) - M4-5 (ULO-)
    Always
    Below 1 Ω
    R14-1 (CSLD) - M4-1 (USD1)
    Always
    Below 1 Ω
    R14-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    R14-3 (CDR-) - Body ground
    Always
    10 kΩ or higher
    R14-4 (CDL+) - Body ground
    Always
    10 kΩ or higher
    R14-5 (CDL-) - Body ground
    Always
    10 kΩ or higher
    R14-1 (CSLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)