Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG CUTOFF SWITCH

CURTAIN SHIELD AIRBAG CUTOFF SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CURTAIN AIRBAG CUTOFF SWITCH


    B203596E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (SW) - 4 (E)
    Pushed
    Below 1 Ω
    3 (SW) - 4 (E)
    Free
    10 kΩ or higher

    If the result is not as specified, replace the curtain airbag cutoff switch.



    B203597E01
  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 2 (ILL+) and the negative (-) battery lead to terminal 1 (ILL-), and then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the illumination does not illuminate, replace the curtain airbag cutoff switch.