Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER

DOOR CONTROL RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    E232350
  1. Disengage the claw and separate the glove compartment door stopper from the glove compartment door assembly.

  1. Slightly deform the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.



    E232351
  1. Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.

  1. Remove the glove compartment door stopper.



2. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH


    E232352
  1. Remove the bolt <B>.

  1. Disengage the 2 clips and remove the instrument panel lower finish panel sub-assembly RH.



3. REMOVE DOOR CONTROL RECEIVER


B203561
  1. Disconnect the connector.

  1. Remove the 2 screws and remove the door control receiver.