Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

This circuit sends a microphone voice signal from the extension module to the radio and display receiver assembly.
Using this circuit, the extension module disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.

WIRING DIAGRAM


E233356E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)
  1. Disconnect the R19 radio and display receiver assembly connector.

  1. Disconnect the E15 extension module connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R19-19 (MIC+) - E15-9 (MIC+)
    Always
    Below 1 Ω
    R19-20 (MIC-) - E15-25 (MIC-)
    Always
    Below 1 Ω
    R19-21 (SHD2) - E15-24 (SHD2)
    Always
    Below 1 Ω
    R19-19 (MIC+) - Body ground
    Always
    10 kΩ or higher
    R19-20 (MIC-) - Body ground
    Always
    10 kΩ or higher
    R19-21 (SHD2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)