Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    CB-13    USB Over Current Detection

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
CB-13
"iPod" or USB device overcurrent malfunction
  1. "iPod" or USB device
  2. No. 1 stereo jack adapter assembly
  3. Harness or connector
  4. Multi-media interface ECU

WIRING DIAGRAM


E232735E01


INSPECTION PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTCs are output.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE 

4.INSPECT MULTI-MEDIA INTERFACE ECU


    E232736E01
  1. Disconnect the N3 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N3-1 - N3-4
    Ignition switch ACC
    5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)  

5.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the M5 multi-media interface ECU connector.

  1. Disconnect the N3 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M5-1 - N3-1
    Always
    Below 1 Ω
    M5-4 - N3-4
    Always
    Below 1 Ω
    M5-1 - Body ground
    Always
    10 kΩ or higher
    M5-4 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)