DTC CB-45 USB Communication Error |
DTC CB-46 iPod Control Error |
DTC CB-47 iPod Communication Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| CB-45 | Communication error with USB device |
|
| CB-46 | "iPod" control software malfunction |
|
| CB-47 | Communication error with "iPod" |
| 1.CHECK CONNECTION METHOD |
Check the method used to connect the USB device or "iPod" to the No. 1 stereo jack adapter assembly.
| Condition | Proceed to |
| USB device or "iPod" is connected using a connection cable. | A |
| USB device is directly connected. | B |
|
| ||||
| A | |
| 2.REPLACE CONNECTION CABLE |
Disconnect the USB device or "iPod" and connection cable from the No. 1 stereo jack adapter assembly.
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good connection cable to the No. 1 stereo jack adapter assembly and connect the USB device or "iPod" to the connection cable.
| NEXT | |
| 3.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 4.RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 5.REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
| NEXT | |
| 6.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7.RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||