Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER


    A165595E03
  1. Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

    OK:
    There is no foreign matter.

    If the result is not as specified, replace the mass air flow meter.
    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)



  1. Check the resistance.


    A165586E07


    Text in Illustration 
    *a
    Component without harness connected
    (MAF Meter)
    *b
    Resistance
    *c
    Temperature
    *d
    Acceptable

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 5 (E2)
      -20°C (-4°F)
      12.5 to 16.9 kΩ
      20°C (68°F)
      2.19 to 2.67 kΩ
      60°C (140°F)
      0.50 to 0.68 kΩ

      If the result is not as specified, replace the mass air flow meter.