Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    B1579    Voice Recognition Microphone Disconnected

for Preparation Click here


DESCRIPTION

The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.
This DTC is stored when the microphone connection detection signal is disconnected.

DTC Code
DTC Detection Condition
Trouble Area
B1579
Telephone microphone signal is lost.
  1. Telephone microphone assembly
  2. Radio and display receiver assembly
  3. Harness or connector

WIRING DIAGRAM


E226291E08


INSPECTION PROCEDURE

NOTICE:
After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY


    E176671E71
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R15-19 (MIN-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component with harness connected
    (Radio and Display Receiver Assembly)



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)
  1. Disconnect the R15 radio and display receiver assembly connector.

  1. Disconnect the T21 telephone microphone assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    R15-6 (SNS2) - T21-3 (SNS2)
    Always
    Below 1 Ω
    R15-19 (MIN-) - T21-4 (MCO-)
    Always
    Below 1 Ω
    R15-6 (SNS2) - Body ground
    Always
    10 kΩ or higher
    R15-19 (MIN-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT TELEPHONE MICROPHONE ASSEMBLY


    E233345E01
  1. Remove the telephone microphone assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (SNS2) - 4 (MCO-)
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    Telephone Microphone Assembly)



NG
REPLACE TELEPHONE MICROPHONE ASSEMBLY (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)