SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Trouble Codes.
Erase the DTCs.
| CLEAR DTC (Without using the Techstream) |
Perform either of the following operations:
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI NO. 1 fuse and ETCS fuse from the engine room relay block located inside the engine compartment for more than 1 minute.