DTC P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0121 | Difference between VTA1 and VTA2 voltages less than 0.8 V, or more than 1.6 V for 2 seconds (1 trip detection logic) | TP sensor (built into throttle body) |
| Related DTCs | P0121: TP sensor rationality |
| Required Sensors/Components (Main) | TP sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | Within 2 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0120, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle position sensor) |
| Either of following conditions A or B set | - |
| A. Ignition switch | ON |
| B. Electric throttle motor power | ON |
| When either condition below is met: | - |
| Difference of TP sensor voltage between VTA and VTA2 x 0.8 | More than 1.6 V |
| Difference of TP sensor voltage between VTA and VTA2 x 0.8 | Less than 0.8 V |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0121) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P0121 is output | A |
| P0121 and other DTCs are output | B |
|
| ||||
| A | ||
| ||