DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic): (a) Throttle actuator duty ratio 80% or more (b) Throttle actuator current less than 0.5 A |
|
| P2103 | Either of following conditions met (1 trip detection logic):
|
|
| Related DTCs | P2102: Throttle actuator current (low current) P2103: Throttle actuator current (high current) |
| Required Sensors/Components (Main) | Throttle actuator (throttle body) |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | 2 seconds: P2102 Within 1 second: P2103 |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Throttle actuator | Activated |
| Duty-cycle ratio to open throttle actuator | 80% or more |
| Throttle actuator power supply | 8 V or more |
| Throttle actuator | Activated |
| Throttle actuator power supply | 8 V or more |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Throttle actuator current | Less than 0.5 A |
| Either of the following conditions is met | Condition 1 or 2 |
| 1. Hybrid IC diagnosis signal | Fails 25 times |
| 2. Hybrid IC current limiter port | Fails for 0.6 seconds |

| 1.INSPECT THROTTLE BODY (RESISTANCE OF THROTTLE ACTUATOR) |
![]() |
Disconnect the D9 throttle body connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 (M+) - 1 (M-) | 20°C (68°F) | 0.3 to 100 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE ACTUATOR - ECM) |
![]() |
Disconnect the D9 throttle body connector.
Disconnect the D74 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D9-2 (M+) - D74-19 (M+) | Always | Below 1 Ω |
| D9-1 (M-) - D74-18 (M-) | Always | Below 1 Ω |
| D9-2 (M+) or D74-19 (M+) - Body ground | Always | 10 kΩ or higher |
| D9-1 (M-) or D74-18 (M-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY ASSEMBLY |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE VALVE |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||