Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

NAVIGATION SYSTEM (for Double Cab) > Voice Recognition Difficulty

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CONDITION
  1. Check if the system's voice recognition level is low by using only one particular voice.

    OK:
    System's voice recognition level is low with any voice.



NG
SYSTEM'S VOICE RECOGNITION LEVEL VARIES DEPENDING ON VOICE AND PRONUNCIATION. THIS IS NOT A MALFUNCTION.
OK


2.CHECK MAP DISC


    I100152E12
  1. Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on map disc.



NG
REPLACE MAP DISC
OK


3.CHECK MAP DISC


    I100201E04
  1. Check for dirt on the map disc surface.

    OK:
    No dirt is on map disc surface.

    HINT:
    If the disc is dirty, clean the disc by wiping the disc surface radially with a soft cloth.

    NOTICE:
    Do not use a conventional record cleaner or antistatic preservative.



NG
CLEAN MAP DISC
OK


4.CHECK MICROPHONE (NAVIGATION CHECK MODE)


    E125118E03
  1. Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).

  1. When a voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    The recording limit is 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END