Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY


    A164765E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (M+) - 1 (M-)
    20°C (68°F)
    0.3 to 100 Ω
    5 (VC) - 3 (E2)
    20°C (68°F)
    1.2 to 3.2 kΩ

    If the result is not as specified, replace the throttle body with motor assembly.