AIR FUEL RATIO SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR FUEL RATIO SENSOR |
![]() |
Disconnect the 2 sensor connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (HA1A) - 2 (+B) | 20°C (68°F) | 1.8 to 3.4 Ω |
| Tester Connection | Condition | Specified Condition |
| 1 (HA2A) - 2 (+B) | 20°C (68°F) | 1.8 to 3.4 Ω |
Connect the 2 sensor connectors.
| 2. INSPECT AIR-FUEL RATIO COMPENSATION SYSTEM |
| Tester Display (Sensor) | Injection Volume | Status | Voltage |
| AFS Voltage B1 S1 or AFS Voltage B2 S1 (A/F) | +25% | Rich | Less than 3.0 V |
| AFS Voltage B1 S1 or AFS Voltage B2 S1 (A/F) | -12.5% | Lean | More than 3.35 V |
| O2S B1 S2 or O2S B2 S2 (HO2) | +25% | Rich | More than 0.55 V |
| O2S B1 S2 or O2S B2 S2 (HO2) | -12.5% | Lean | Less than 0.4 V |
| Case | A/F Sensor (Sensor 1) Output Voltage | HO2 Sensor (Sensor 2) Output Voltage | Main Suspected Trouble Area |
| 1 | ![]() ![]() | ![]() ![]() | - |
| 2 | ![]() ![]() | ![]() ![]() |
|
| 3 | ![]() ![]() | ![]() ![]() |
|
| 4 | ![]() ![]() | ![]() ![]() |
|