Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


B166364E01
  1. Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.

  1. Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. w/ Power mirror control system:
    Connect the connector labeled A.



2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B165684E03
  1. Connect the 2 cables to the inside handle.

  1. Attach the inside handle's knob to the door trim board.

  1. Attach the 10 clips to install the door trim board.



    B167314E01
  1. Install the inside handle and door trim board to the door trim panel with the screw.

  1. Install the door trim board to the door panel with the screw.

  1. Attach the clip.



3. INSTALL COURTESY LIGHT ASSEMBLY (w/ Power Window)


    B165683
  1. Attach the claw to install the courtesy light.

  1. Connect the connector.



4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


    B165652
  1. Attach the 3 clips to install the front lower door frame bracket garnish.



5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B165697E01
  1. Install the plate and regulator handle with the snap ring.

    HINT:
    With the door window fully closed, install the plate and the regulator handle with the snap ring as shown in the illustration.



6. INSTALL FRONT ARMREST UPPER BASE PANEL (w/ Power Window)


    B165649E01
  1. Connect the connectors.

  1. Attach the 2 clips to install the front upper armrest base panel.



7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B165648E01
  1. Attach the 4 claws to install the bezel plug.