Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B165648
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT ARMREST UPPER BASE PANEL


    B165649
  1. Using a screwdriver, detach the 2 clips and front upper armrest base panel.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors.



3. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B084267E03
  1. Insert a clip remover between the plate and trim.

  1. Turn the handle clockwise to remove the handle.



4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B165652
  1. Detach the 3 clips and front lower door frame bracket garnish.



5. REMOVE COURTESY LIGHT ASSEMBLY (w/ Power Window)


    B165655
  1. Detach the claw and remove the courtesy light.

  1. Disconnect the connector.



6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B167314E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 10 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


B166364E02
  1. w/ Power Mirror Control System:
    Disconnect the connector labeled A.

  1. Remove the 3 nuts and claw.

  1. Remove the outer rear view mirror.