AUTOMATIC TRANSMISSION SYSTEM (for 2UZ-FE) > DTC CHECK / CLEAR |
| CHECK DTC |
DTCs which are stored in the ECM can be displayed on the Techstream.
The Techstream can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Confirm the DTCs and freeze frame data, and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC (using the Techstream) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / DTC / Clear.
| CLEAR DTC (without using the Techstream) |
Perform either of the following operations.
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI NO. 1 fuse from the engine room relay block located inside the engine compartment for more than 1 minute.