AUTOMATIC TRANSMISSION SYSTEM > ROAD TEST |
| PROBLEM SYMPTOM CONFIRMATION |
Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transmission does not shift up, shift down, or the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and simulate the problem symptoms.
| ROAD TEST |
D position test
Shift into the D position, fully depress the accelerator pedal and check the following points.
Check up-shift operation.
Check that the 1 → 2, 2 → 3, 3 → 4 and 4 → 5 up-shifts take place at the shift points shown in the automatic shift schedule (Click here).
Check for shift shock and slippage.
Check for shock and slippage at the 1 → 2, 2 → 3, 3 → 4 and 4 → 5 up-shifts.
Check for abnormal noise and vibration.
Check for abnormal noise and vibration when up-shifting from 1 → 2, 2 → 3, 3 → 4 and 4 → 5 while driving with the shift lever in the D position, and also check while driving in the lock-up condition.
Check kick-down operation.
Check the vehicle speeds when the 2 → 1, 3 → 2, 4 → 3, and 5 → 4 kick-downs take place while driving with the shift lever in the D position. Confirm that each speed is within the applicable vehicle speed range indicated in the automatic shift schedule (Click here).
Check for abnormal shock and slippage at kick-down.
Check the lock-up mechanism.
S position test
Check shift operation.
R position test
Shift into the R position, lightly depress the accelerator pedal, and check that the vehicle moves backward without any abnormal noise or vibration.
P position test
Stop the vehicle on an incline (more than 5°) and after shifting into the P position, release the parking brake. Then, check that the parking lock pawl holds the vehicle in place.