Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE)

AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE) > HYDRAULIC TEST

for Preparation Click here



PERFORM HYDRAULIC TEST


  1. Measure the line pressure.

    CAUTION:
    The line pressure test should always be carried out in pairs. One technician should observe the conditions of the wheels and wheel stoppers from outside the vehicle while the other is performing the test.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature: 50 to 80°C (122 to 176°F).
    2. Be careful to prevent SST hose from interfering with the exhaust pipe.
    3. This check must be conducted after checking and adjusting the engine.
    4. Perform with the A/C OFF.
    5. When conducting the stall test, do not continue for more than 5 seconds.


    1. Warm up the ATF (Automatic Transmission Fluid).

    2. Turn the ignition switch off.

    3. Lift the vehicle up.



    4. C159068E01
    5. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09992-00095   (09992-00231, 09992-00271)

    6. Lower the vehicle.

    7. Fully apply the parking brake and chock the 4 wheels.

    8. Start the engine and check the idling speed.

    9. Keep your left foot pressed firmly on the brake pedal and shift into the D position.

    10. Measure the line pressure when the engine is idling.

    11. Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches stall speed.

    12. In the same manner, perform the test with the shift lever in the R position.

      Specified line pressure: 
      Condition
      D position kPa (kgf/cm2, psi)
      R position kPa (kgf/cm2, psi)
      Idling
      350 to 430 kPa
      (3.6 to 4.4 kgf/cm2, 51 to 62 psi)
      520 to 630 kPa
      (5.3 to 6.4 kgf/cm2, 75 to 91 psi)
      Stall test
      1360 to 1480 kPa
      (13.9 to 15.1 kgf/cm2, 197 to 215 psi)
      1290 to 1520 kPa
      (13.2 to 15.5 kgf/cm2, 187 to 220 psi)

      Evaluation: 
      Problem
      Possible cause
      Measured values at all positions are higher than specified pressure
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured values at all positions are lower than specified pressure
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leak
      2. Clutch No. 1 (C1) defective
      Pressure is low in R position only
      1. R position circuit fluid leak
      2. Clutch No. 3 (C3) defective
      3. Brake No. 4 (B4) defective