Home › ENGINE · 1GR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT INJECTOR ASSEMBLY


    A165058E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    11.6 to 12.4 Ω

    If the result is not as specified, replace the injector assembly.



2. INSPECT INJECTION VOLUME AND LEAKAGE


    A133706E02
  1. Check the injector injection.

    CAUTION:
    1. This test involves high-pressure fuel and electricity.
    2. Take every precaution regarding safe handling of both the fuel and the electrical parts.
    3. Perform this test in a safe area, and avoid any sparks or flame.
    4. Do not smoke.


    1. Assemble SST as shown in the illustration.

      SST
      09268-31011   (90467-13001, 09268-41091, 09268-41120, 09268-41500, 95333-06030, 95336-08070)
      09268-41140  
      09268-41400  

    2. Discharge the fuel system pressure.

    3. Disconnect the fuel inlet hose (fuel tube connector) from the No. 1 fuel pipe.

    4. Remove the bolt and disconnect the fuel pressure regulator from the fuel delivery pipe.

      NOTICE:
      Do not disconnect the No. 2 fuel pipe from the fuel pressure regulator.



    5. A158335E01
    6. Connect SST to the No. 1 fuel pipe.

      CAUTION:
      Always read the precautions before connecting the fuel tube connector.



    7. A111937E02
    8. Connect SST (hose) to the fuel inlet of the pressure regulator with another SST (union) and the 2 bolts.

      SST
      09268-31011   (09268-41091, 95336-08070)

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    9. Connect the fuel return hose to the fuel outlet of the pressure regulator.



    10. A111938E03
    11. Install a new O-ring to the injector.

    12. Connect SST (adapter and hose) to the injector, and hold the injector and adapter with SST (clamp).

      SST
      09268-31011   (95336-08070)
      09268-41140  
      09268-41400  

    13. Put the injector into a graduated cylinder.

      HINT:
      Install a suitable vinyl tube onto the injector to contain any gasoline spray.

    14. Operate the fuel pump.



    15. A111939E02
    16. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30080  

      Standard volume:
      Injection Volume
      Difference Between Each Injector
      76 to 91 cm3 (4.6 to 5.5 cu in.) per 15 seconds
      15 cm3 (0.9 cu in.) or less

      NOTICE:
      Always turn the voltage on and off on the battery side, not the fuel pump side.

      If the result is not as specified, replace the injector assembly.



    A075916E02
  1. Check for fuel leak.

    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leak from the injector.

      Fuel leak:
      1 drop or less per 16 minutes