POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck the DTCs (Click here).
| Result | Proceed to |
| DTC does not reoccur | A |
| DTC reoccurs | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
Data List/Active Test (Click here).
| |||||
| 7.REPAIR |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|