Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for Double Cab)

NAVIGATION SYSTEM (for Double Cab) > TERMINALS OF ECU

for Preparation Click here



CHECK NAVIGATION RECEIVER

E138049E01

  1. Disconnect the K18 receiver connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    K18-20 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    K18-1 (B) - K18-20 (GND)
    L - W-B
    Battery
    Always
    11 to 14 V
    K18-11 (ACC) - K18-20 (GND)
    GR - W-B
    ACC power supply
    Ignition switch OFF
    Below 1 V
    K18-11 (ACC) - K18-20 (GND)
    GR - W-B
    ACC power supply
    Ignition switch ACC
    11 to 14 V

    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the K18 receiver connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    K18-2 (ILL+) - K18-20 (GND)
    SB - W-B
    Illumination signal
    Light control switch OFF
    Below 1 V
    K18-2 (ILL+) - K18-20 (GND)
    SB - W-B
    Illumination signal
    Light control switch TAIL or HEAD
    11 to 14 V
    K18-12 (ILL-) - K18-20 (GND)
    BE - W-B
    Illumination signal
    Light control switch OFF
    Below 1 V
    K18-12 (ILL-) - K18-20 (GND)
    BE - W-B
    Illumination signal
    Light control switch TAIL or HEAD
    11 to 14 V
    K18-15 (ATX-) - K18-20 (GND)
    P - W-B
    AVC-LAN communication signal
    Ignition switch ACC
    2 to 3 V
    K18-5 (ATX+) - K18-20 (GND)
    V - W-B
    AVC-LAN communication signal
    Ignition switch ACC
    2 to 3 V
    K21-13 (SLD1) - K18-20 (GND)
    Shielded - W-B
    Shielded ground
    Always
    Below 1 V
    K21-12 (IVO-) - K18-20 (GND)
    BR - W-B
    Voice guidance signal
    Voice guidance is provided
    Waveform synchronized with sounds is output
    K21-11 (IVO+) - K18-20 (GND)
    Y - W-B
    Voice guidance signal
    Voice guidance is provided
    Waveform synchronized with sounds is output
    K18-7 (MUTE) - K18-20 (GND)
    GR - W-B
    Mute signal
    Audio system playing → changing modes
    Above 3.5 → Below 1 V
    K18-10 (SLD) - K18-20 (GND)
    Shielded - W-B
    Shielded
    Always
    Below 1 V
    K18-8 (R+) - K18-20 (GND)
    W - W-B
    Sound signal (right)
    Audio system is playing
    Waveform synchronized with sound is output
    K18-18 (R-) - K18-20 (GND)
    R - W-B
    Sound signal (right)
    Audio system is playing
    Waveform synchronized with sound is output
    K18-9 (L+) - K18-20 (GND)
    G - W-B
    Sound signal (left)
    Audio system is playing
    Waveform synchronized with sound is output
    K18-19 (L-) - K18-20 (GND)
    B - W-B
    Sound signal (left)
    Audio system is playing
    Waveform synchronized with sound is output
    K6-3 (SPD) - K18-20 (GND)
    W - W-B
    Speed signal from combination meter
    See "Vehicle Signal Check" mode (Click here)
    -
    K7-12 (TSW-) - K18-20 (GND)
    W-B - W-B
    Telephone related switch ground
    Always
    Below 1 V
    K7-18 (SGND) - K18-20 (GND)
    W-B - W-B
    Telephone related switch ground
    Always
    Below 1 V
    K6-5 (REV) - K18-20 (GND)
    G - W-B
    Reverse signal
    See "Vehicle Signal Check" mode (Click here)
    -
    K5-3 (VAL+) - K18-20 (GND)
    B - W-B
    Aux sound signal (left)
    External device is playing (When stereo jack is used)
    Waveform synchronized with sound is output
    K5-2 (VAR+) - K18-20 (GND)
    R - W-B
    Aux sound signal (right)
    External device is playing (When stereo jack is used)
    Waveform synchronized with sound is output
    K5-5 (VA-) - K18-20 (GND)
    W - W-B
    Shielded ground
    Always
    Below 1 V
    K5-6 (ADPG) - K18-20 (GND)
    SB - W-B
    External device connection detection signal
    External device is connection
    Below 1 V
    K21-7 (SW1) - K18-20 (GND)
    LG - W-B
    Steering pad switch signal
    Steering switch not pushed
    4 to 6 V
    K21-7 (SW1) - K18-20 (GND)
    LG - W-B
    Steering pad switch signal
    Steering switch Seek+ switch pushed
    Approx. 0.5 V
    K21-7 (SW1) - K18-20 (GND)
    LG - W-B
    Steering pad switch signal
    Steering switch Seek- switch pushed
    Approx. 0.9 V
    K21-7 (SW1) - K18-20 (GND)
    LG - W-B
    Steering pad switch signal
    Steering switch Volume+ switch pushed
    Approx. 2.0 V
    K21-7 (SW1) - K18-20 (GND)
    LG - W-B
    Steering pad switch signal
    Steering switch Volume- switch pushed
    Approx. 3.4 V
    K21-6 (SWG) - K18-20 (GND)
    BR - W-B
    Steering pad switch signal
    Always
    Below 1 V
    K21-8 (SW2) - K18-20 (GND)
    GR - W-B
    Steering pad switch signal
    Steering switch not pushed
    4 to 6 V
    K21-8 (SW2) - K18-20 (GND)
    GR - W-B
    Steering pad switch signal
    Steering switch MODE pushed
    Approx. 0.5 V
    K21-8 (SW2) - K18-20 (GND)
    GR - W-B
    Steering pad switch signal
    Steering switch On Hook pushed
    Approx. 0.9 V
    K21-8 (SW2) - K18-20 (GND)
    GR - W-B
    Steering pad switch signal
    Steering switch Off Hook pushed
    Approx. 2.0 V
    K21-8 (SW2) - K18-20 (GND)
    GR - W-B
    Steering pad switch signal
    Steering switch Voice pushed
    Approx. 3.4 V
    K7-24 (CA+) - K18-20 (GND)
    B - W-B
    Television camera power supply
    Ignition switch ON, shift lever R position
    5.5 to 7.05 V
    K7-21 (CGND) - K18-20 (GND)
    W - W-B
    Television camera signal ground
    Always
    Below 1 V
    K7-22 (V+) - K7-21 (CGND)
    R - W
    Television camera image signal
    Ignition switch ON, shift lever R position
    Pulse generation (refer to waveform)
    K7-23 (V-) - K18-20 (GND)
    Shielded - W-B
    Shielded ground
    Always
    Below 1 V
    K7-17 (MACC) - K18-20 (GND)
    LG - W-B
    Microphone amplifier power supply
    Ignition switch ACC
    4 to 6 V
    K7-19 (MIC+) - K18-20 (GND)
    BR - W-B
    Microphone voice signal
    See "Microphone & Voice Recognition Check" (Click here)
    -
    K7-20 (MIC-) - K18-20 (GND)
    Y - W-B
    Microphone voice signal
    See "Microphone & Voice Recognition Check" (Click here)
    -

    1. If the result is not as specified, the receiver may have a malfunction.



  5. E119731E01
  6. Using an oscilloscope, check the waveform.
    Waveform (reference) 
    Item
    Content
    Terminal No. (Symbols)
    K7-22 (V+) - K7-21 (CGND)
    Tool Setting
    0.2 V/DIV., 0.2 μs/DIV.
    Condition
    Ignition switch ON, shift lever R position


CHECK STEREO COMPONENT AMPLIFIER (Click here)