NAVIGATION SYSTEM (for CrewMax) > DTC CHECK / CLEAR |
| START DIAGNOSTIC MODE |
Turn the ignition switch ACC.
![]() |
Press the "DISP" switch.
![]() |
From the display quality adjustment screen, touch the corners of the screen in the following order: upper left → lower left → upper left → lower left → upper left → lower left.
The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result will be displayed.
| FINISH DIAGNOSTIC MODE |
Turn the ignition switch OFF.
| DIAGNOSIS MENU |
![]() |
The "Diagnosis MENU" screen will be displayed by pressing the "Menu" switch on the "System Check Mode" screen.
| CHECK DTC |
![]() |
Read the system check result.
If the check result is "EXCH", "CHEK" or "Old", touch the displayed check result to view the results on the "Unit Check Mode" screen and record them.
![]() |
Read the communication diagnostic check result.
Return to the "System Check Mode" screen, and press the "LAN Mon" switch to enter the "LAN Monitor" screen.
![]() |
If the check result is "CHEK" or "Old", touch the displayed check result to view the results on the individual communication diagnostic screen and record them.
| DTC CLEAR/RECHECK |
![]() |
Clear DTC
Press the "Code CLR" switch for 3 seconds.
The check results are cleared.
![]() |
Recheck DTC
Press the "Recheck" switch.
![]() |
Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.
![]() |
Press the "LAN Mon" switch to change to the "LAN Monitor" screen.
![]() |
Confirm that all diagnostic codes are "No Err". If a code other than "No Err" is displayed, troubleshoot again.