Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > Navigation Receiver Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

The circuit provides power to the navigation receiver.

WIRING DIAGRAM


E138083E01


INSPECTION PROCEDURE

1.INSPECT FUSE (RAD NO. 1, ACC)
  1. Disconnect the ACC fuse from the main body ECU.

  1. Disconnect the RAD NO. 1 fuse from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    RAD NO. 1 fuse
    Always
    Below 1 Ω
    ACC fuse



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - BATTERY AND BODY GROUND)


    E138077E02
  1. Disconnect the K18 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K18-20 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K18-1 (B) - Body ground
    Always
    11 to 14 V
    K18-11 (ACC) - Body ground
    Ignition switch ACC



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)