Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab)

AUDIO AND VISUAL SYSTEM (for Regular Cab and Double Cab) > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM


E146482E06


INSPECTION PROCEDURE

1.INSPECT FUSE (AMP, ACC)
  1. Disconnect the AMP fuse from the engine room junction block.

  1. Disconnect the ACC fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    AMP fuse
    Always
    Below 1 Ω
    ACC fuse



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (AMPLIFIER - BATTERY AND BODY GROUND)


    E107220E03
  1. Disconnect the K16, K15 and K17 amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K17-6 (GND) - Body ground
    Always
    Below 1 Ω
    K17-7 (GND2) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K16-1 (+B) - K17-6 (GND)
    Always
    11 to 14 V
    K16-5 (+B2) - K17-6 (GND)
    K15-12 (ACC) - K17-6 (GND)
    Ignition switch ACC



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)