Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › MAGNETIC CLUTCH RELAY

MAGNETIC CLUTCH RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT MAGNETIC CLUTCH RELAY (MG CLT)


B060778E90
  1. Remove the magnetic clutch relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage is not applied between terminals
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.

  1. Install the magnetic clutch relay.