FRONT BRAKE > INSPECTION |
| 1. CHECK BRAKE CALIPER AND PISTON |
Check the caliper bore and piston for rust or scoring.
If necessary, replace the disc brake caliper assembly.
| 2. CHECK PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| 3. CHECK FRONT DISC BRAKE ANTI-RATTLE SPRING |
Use brake cleaner to clean the front disc brake anti-rattle spring. Check for deformation and cracks.
When installing the front disc brake anti-rattle spring to the front disc brake caliper, check that the spring's force is applied to the hole pin and brake pad.
| 4. CHECK DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| 5. CHECK DISC RUNOUT |
![]() |
Using SST to hold the disc, fix the disc in place with the 5 hub nuts.
![]() |
Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.
Remove the 5 hub nuts and front disc.