Home › ENGINE · 1GR-FE › INTAKE › VACUUM SWITCHING VALVE (for ACIS)

VACUUM SWITCHING VALVE (for ACIS) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
  1. Disconnect the VSV connector.



    A085583E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Condition
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    37 to 44 Ω
    1 - Body ground
    Always
    1 MΩ or higher
    2 - Body ground

    If the result is not as specified, replace the VSV assembly.



  1. Check the VSV operation.



      A163863E01
    1. When applying a vacuum to port E, check that air is sucked into the filter.
      If the result is not as specified, replace the VSV assembly.



    2. A163864E01
    3. Apply battery voltage across the terminals.

    4. When applying a vacuum to port F, check that air is sucked into port E.
      If the result is not as specified, replace the VSV assembly.

  1. Connect the VSV connector.