Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE) > INSPECTION

for Preparation Click here



1. INSPECT MAGNET CLUTCH ASSEMBLY


E168822E01
  1. Check the magnet clutch operation.

    1. Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 3 of the magnet clutch, and the negative lead is connected to the ground wire.
      If the operation is not as specified, replace the magnet clutch assembly.

  1. Measure the resistance.

  1. Measure the resistance between terminals 1 and 2.

    Standard resistance:
    65 to 125 Ω at 20°C (68°F)
    If the resistance is not as specified, replace the cooler compressor assembly.