Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE) > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


E168820
  1. Detach the 2 clamps.

  1. Remove the screw and the cooler bracket.



2. REMOVE MAGNET CLUTCH ASSEMBLY


E168821E01
  1. Clamp the cooler compressor in a vise.

  1. Using SST, hold the magnet clutch hub.

    SST
    09985-00270  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.



    I104018
  1. Using a snap ring expander, remove the snap ring and the magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.



    I104019
  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.