FRONT DRIVE SHAFT ASSEMBLY (for 4WD) > DISASSEMBLY |
| 1. REMOVE INBOARD JOINT BOOT CLAMP |
Using a side cutter, cut the 2 inboard joint boot clamps and remove them.
| 2. DISCONNECT INBOARD JOINT BOOT |
Disconnect the inboard joint boot from the inboard joint shaft.
| 3. REMOVE INBOARD JOINT SHAFT |
![]() |
Place matchmarks on the inboard joint shaft and outboard joint shaft.
Using a screwdriver, remove the snap ring from the outboard joint shaft.
Remove the inboard joint shaft from the outboard joint shaft.
![]() |
Place matchmarks on the outboard joint shaft, inner race and cage.
Remove the 6 balls.
Slide the cage to the outboard joint side.
![]() |
Using a snap ring expander, remove the snap ring.
![]() |
Using a brass bar and hammer, tap out the inner race.
Remove the cage.
| 4. REMOVE INBOARD JOINT BOOT |
Remove the inboard joint boot from the outboard joint shaft.
| 5. REMOVE OUTBOARD JOINT BOOT CLAMP |
Using a side cutter, cut the 2 outboard joint boot clamps and remove them.
| 6. REMOVE OUTBOARD JOINT BOOT |
Remove the outboard joint boot from the outboard joint shaft.
| 7. REMOVE FRONT DRIVE SHAFT DUST COVER LH |
![]() |
Using SST and a press, press out the dust cover.
| 8. REMOVE DUST SEAL |
![]() |
Using SST and a press, press out the dust seal.